Levelling Compounds

UltraTile’s range of floor levelling compounds includes a range of different formulations for different applications, giving you access to the right product for the job every time.

Looking for a versatile leveller that can be applied on a range of subfloors and over old adhesive residues? ProLevel Ultimate is for you.

Need a floor leveller suitable for depths up to 60mm in a single application? ProLevel One’s formulation enables early fixing of tiles even at thicker depth applications.

If time is of the essence, our rapid-drying ProLevel Rapid leaves a strong, sound base that’s ready to accommodate tiling after only 45 minutes.

Meanwhile, providing maximum flexibility for timber floors and underfloor heating, our ProLevel Fibre is mixed with specially graded fillers, cements and fibres.

The steps for application will vary slightly depending on which of our levellers you have selected. We therefore recommend referring to the individual leveller’s spec sheet before applying.

However, many of the steps can be transferred across our different products, as follows.

Step 1:
Prepare your substrate. How exactly you do this will depend on the substrate itself – if you’re applying on concrete, this will be a different process to applying on an existing smoothing underlayment. Check your specific leveller’s datasheet for more information.

Step 2:
Mix powder and water, if required, to your product’s specific ratio. You should be looking to create a lump-free, creamy material.

Step 3:
Apply your product by pouring it onto the floor and spreading with a smooth-edged steel trowel. Begin at the furthest point of the room and work backwards to the doorway to avoid walking on wet product.

Step 4:
Leave to cure according to product instructions.

Step 5:
Apply tiles of choice once your cure is fully completed.

Our range of self-levelling compounds have a number of benefits that will help deliver a high-performance:

• Easy to install: The best self-levellers require minimal manual application.
• Quick curing: Our products provide a leading cure in as little as 45 minutes.
• Flexible: Our products can be used with a range of subfloors and tile types.
• Versatile: Whether you need leveller for a commercial or residential application, we have you covered.

A mixture of cement, aggregates and additives that uses gravity to level itself out, creating a level surface on which to apply your flooring.

This will depend entirely on which of our self-levelling compounds you are using. If you are using our ProLevel Rapid floor levelling compound, you will have an even, ready base for tiling after just 45 minutes.

Yes, our self-levelling compounds are waterproof, making them suitable for use in damp areas.

Fill a bucket to around two-thirds full with cold water, then add the self-levelling compound. Give it a good mix until it is smooth and lump-free.

Remember to check that the self-levelling compound mixture is not too crumbly or watery before applying – this will deliver a smooth finish.

You can tile on self-levelling compound once it has cured, which typically takes between 30 minutes and 48 hours, depending on which self-levelling compound is used.

For best results, we recommend using UltraTile ProPrimer before laying any of our self-levelling compounds or cements. This versatile primer is suitable for use on a huge range of different substrates.